Gas line repair and installation in Matthews, NC
Putting a gas range where the electric one used to be, adding gas logs to the family room, or tracking down a leak on the old black iron under the house? In Matthews we handle the piping past the meter, the county permit and the pressure test, with a flat price agreed before we start.

Switching a Matthews kitchen or laundry from electric to gas

A lot of the subdivisions off Weddington Road and Matthews-Mint Hill Road went up in the 80s and 90s with a gas furnace and a gas water heater, then an electric range and an electric dryer. The builder ran gas to the two things that needed it and stopped there. So when someone in one of those houses decides they want to cook over a flame, the gas is usually already sitting in the crawl space a short distance from the kitchen.
That makes most of these conversions a short tap off the existing line and a new run up through the floor, which typically lands somewhere in the $350 to $800 range. The piece people forget is power. A gas range still wants a regular 120-volt outlet for the igniters, and the big 240-volt range circuit doesn't help it. We'll point that out on the first visit so you can line up an electrician and the kitchen only gets pulled apart once.
We also do the math before we tee in. That original branch was sized for a furnace and a 40 gallon tank. One range on top is usually fine. A range, a dryer and a fireplace insert all at once can be more than a half-inch line can carry, and then a burner flutters every time the furnace kicks on.
Forty years of black iron in a damp crawl space

Matthews houses from that era are piped in threaded black steel, and the pipe itself holds up for a very long time. The trouble is where it lives. We crawl under homes where a hanger rusted off years ago and the line has been resting on red clay ever since, or where a joint sealed in 1988 has finally dried out. Most leaks turn out to be at a union by the furnace, an old appliance valve, or a fitting someone added during a remodel without testing it.
Fixing a leaking fitting or connector usually runs $150 to $400. A section that has rusted on the outside gets cut out and replaced, typically $400 to $800. And if we find one of those old uncoated brass flex connectors behind a range or dryer, we'll recommend swapping it with a new valve, which is generally $150 to $350. Those connectors crack where they bend, and they were taken off the market for a reason.
Gas logs, grills and a line out to the patio

The other request we get a lot in Matthews is outdoor. A grill stub on the back deck, a gas fire pit on the patio, or gas logs in a family room fireplace that has been burning wood since the house was built. Each one is a new branch off your house piping. Underground runs go in coated pipe or polyethylene made for burial, deep enough to stay out of the way of a shovel, with a shutoff you can actually get to. A longer run across the house or out to the yard usually falls between $800 and $1,800.
Piedmont Natural Gas owns the meter and the service line up to it. If the new load is more than the meter can feed, you'd ask Piedmont for an upgrade, and we tell you that before any digging starts.
Rotten egg smell under the house? Leave it alone and walk out
Please don't go poking around the crawl space with a flashlight looking for it. Get everyone out through the nearest door, leave the light switches and the garage door opener alone, and once you're down at the end of the driveway, call Piedmont Natural Gas or 911. They come out at no charge and shut off or tag whatever is leaking. After that, call us and we'll repair the piping on your side of the meter.
Matthews is in Mecklenburg County, so new lines and most repairs get a county permit and an inspection. We cap the piping, pressurize it, and the gauge has to hold before the inspector signs off and the gas goes back on.
Gas line repair and installation in Matthews, NC questions
Can you add a gas range to a Matthews house that only has gas for the furnace?
Usually, yes. Most Matthews homes from the 80s and 90s already have gas running through the crawl space to the furnace and water heater, so we tap that line and bring a new run up to the kitchen. We check the line size against everything it will feed first. A short run like that typically costs $350 to $800, and you'll need a standard outlet behind the range for the igniters.
Do I need a permit to run a gas line in Matthews?
Yes. Matthews sits in Mecklenburg County, and the county requires a permit for new gas piping and most repairs. We pull it, pressure test the line, and schedule the inspection. The gas can't go into service until the inspector signs off, which usually takes a day or two. Our flat price includes the permit and inspection.
Should I replace the old brass connector behind my dryer?
If it's the old uncoated brass type, yes. Those connectors were common in houses built before the mid-90s and they can crack at the bends after years of the appliance being pulled out and pushed back. Replacing it with a new coated connector and shutoff valve usually costs $150 to $350, and it's a quick job while we're already there.
How long until my gas is back on after a leak repair?
A single bad fitting or valve is often fixed and tested the same visit. If the utility red-tagged the system, it stays off until the repair passes a pressure test, and when a permit is involved the inspector has to sign off before Piedmont relights. Most Matthews repairs are back in service within a day or two.
What Charlotte Homeowners Say
We're new to Charlotte, and we're building our reputation the only honest way there is: one job at a time, done right, at the price we quoted. Every Hornets Nest job comes with flat-rate pricing, a licensed and insured crew, and a real person answering the phone 24/7.
Want gas in the kitchen or out on the patio?
Tell us what the new line needs to feed and we'll give you a flat price that covers the Mecklenburg permit and the test.
📞 Call (704) 419-7362