Open 24 hours, seven days a week โ€ข Charlotte, NC Call (704) 419-7362Request service

Whole-house repiping in Charlotte, NC

Tired of paying for one leak after another? A repipe swaps every supply line in the house for new pipe in a few days, and you sleep at home the whole time. We look at what you have, tell you honestly if it is time, and give you a flat price before anything starts.

Signs your house is due

A corroded fitting on gray polybutylene water pipeA weak stream of water from a shower head in a home with old pipes

Three kinds of pipe account for nearly every repipe we do around Charlotte. Gray polybutylene, put in from about 1978 to 1995, is all over University City, Matthews, east Charlotte and Gastonia. It looks fine for years and then lets go at a fitting with no warning, and plenty of insurers either charge more for it or refuse to write the policy. Galvanized steel in pre-1960 houses rusts shut from the inside. You get strong pressure at the hose bib and a dribble at the upstairs shower, plus brown water after the line sits.

The third is copper with pinholes. Usually it is a green crust or a tiny spray on a horizontal run in the crawl space. One pinhole can be a fluke. When they start showing up in different rooms, the pipe wall is thinning everywhere. Our rule of thumb: the second poly leak, or the day galvanized pressure starts bugging you every morning, is when to stop patching. Every repair after that is money you would have put toward the repipe anyway.

Picking the pipe: PEX or copper

New red and blue PEX lines installed along the joists during a Charlotte repipe

We run PEX on most Charlotte repipes. It costs a lot less, it bends around joists so we open fewer walls, it will not pinhole, and it handles a January cold snap better than copper because it can swell a little instead of splitting. Copper is still good pipe and lasts a very long time. Some people want it for resale or just prefer it, and that is a fair call if the budget is there. Even on a PEX job we use short copper stubs at the water heater, where the heat is hardest on plastic. We lay out both side by side in our PEX vs copper comparison, and we will quote both if you want to see the difference on your house.

Crawl space houses vs slab houses

Small wall opening showing new PEX lines dropped from the attic in a slab home repipeA slab-on-grade house with pine trees in a Charlotte-area subdivision

The foundation decides how the job goes. A one-story brick ranch on a crawl space is the easy case. We run new trunk lines under the floor, come straight up through the floor plate to each fixture, and the house usually ends up with only a few small openings, mostly behind toilets and at the kitchen sink. That is why crawl space homes sit at the low end of the price range.

Slab homes, common in newer subdivisions around Huntersville, Indian Trail and Steele Creek, have the old pipe buried in the concrete. We do not break up the slab. We abandon the old lines in place and reroute new ones through the attic and down inside the walls, insulating every run in the attic so it does not freeze. It works well. It just means more wall openings and a higher price. Two-story homes add a few holes between floors either way.

A normal week during a repipe

Plumber installing new shutoff valves during a whole-house repipe with the family at home

Most houses take 2 to 4 days. On day one we map every fixture, protect the floors, shut the water off in the morning and start pulling new lines. Water comes back on most evenings, so you can cook, shower and sleep at home. Nobody has to move out. The middle days are fixture tie-ins, new quarter-turn shutoffs under every sink and toilet, a new main valve, and a pressure test on the whole system. Then the county inspector signs off on the permit, which we pull, and we close up.

About drywall. Plumbers cut clean, small squares where we need access, and we patch them flat. Texture matching and paint are usually separate. Some people do it themselves; others hire a painter, typically $300 to $800. We tell you up front which way your quote is written so there is no surprise at the end. Expect some dust and drilling noise the first two days. After that it gets quiet fast.

Repipe pricing around Charlotte

A PEX repipe on a two-bedroom, one-bath crawl space home usually runs $4,000 to $5,500. A one-story three-bedroom, two-bath is typically $5,000 to $6,500, and a two-story with three or four bedrooms tends to land between $6,000 and $8,000. Large homes and slab builds start around $8,000. Copper costs roughly twice as much. The things that move a price are the number of bathrooms, how many floors the lines have to climb, and whether we can work from a crawl space or have to go through the attic. Adding a new main shutoff and replacing old supply hoses while we are there costs little extra, since the water is already off. We walk the house, count the fixtures, and hand you a flat price before work begins. Here is the full repipe cost guide.

FAQ

Whole-house repiping questions

Can I stay in my house during a repipe?

Yes. On nearly every job the water is off during the work day and back on by evening, so you can shower, cook and sleep at home. The noisiest part is drilling through studs and floor plates in the first couple of days. Pets usually do better in a closed room or with a friend for those days.

How long does it take to repipe a house?

Two to four days covers most Charlotte homes. A small one-story on a crawl space can be finished in two. A large two-story or a slab home rerouted through the attic takes closer to four. Add a day or so for the county inspection and for drywall patching once the new lines pass the pressure test.

Is repiping worth it, or should I keep fixing leaks?

One leak on otherwise healthy pipe is just a repair. A second polybutylene leak, pinholes showing up in different rooms, or galvanized pressure that keeps fading are signs the whole system is wearing out. At that point each patch adds to a bill that ends in a repipe anyway. Insurance and resale usually improve once the old pipe is gone.

Do I need a permit to repipe a house in Mecklenburg County?

Yes. A whole-house repipe needs a plumbing permit and a county inspection in Mecklenburg and the surrounding counties. We pull the permit as part of the job and schedule the inspection. Keep the paperwork, because buyers, home inspectors and insurance companies sometimes ask for proof the polybutylene or galvanized was replaced properly.

Will you have to tear out a lot of drywall?

Less than most people picture. In a crawl space home, many lines come up through the floor and we only open a few small spots. Slab and two-story homes need more access holes along the walls and ceilings. We cut neat squares, patch them, and tell you in the quote whether texture and paint are included.

What Charlotte Homeowners Say

We're new to Charlotte, and we're building our reputation the only honest way there is: one job at a time, done right, at the price we quoted. Every Hornets Nest job comes with flat-rate pricing, a licensed and insured crew, and a real person answering the phone 24/7.

Review us on GoogleCall (704) 419-7362

Done patching the same old pipes?

Call and we will look at what you have, tell you straight whether a repipe makes sense, and give you a flat price.

๐Ÿ“ž Call (704) 419-7362
๐Ÿ“ž Tap to call (704) 419-7362